Online orders are operating as normal. Read more here »
This is a straight replacement if your anti skating weight is damaged or lost.
The Anti-Skate Weight is attached to a thin fishing wire that hoops onto the rear of some tonearms and hangs over the Anti-Skate Hoop. This allows for the perfect amount of counter-drag on the tonearm (all tonearms have a natural side-ways momentum), reducing the inclination to 'skip' or 'skate'. This weight is a perfect replacement for most tonearms which use this type of weight. Also handy as a spare.
Weight is 4grams, 8.8mm diameter, 80mm from bottom to thread loop.
*Please Note: This weight is supplied pre-attached to the fishing wire. 4.0g weight, including the nylon line
For my last slowly in process SME 'Improved' in heavy effective mass conversion I needed such a heavier bias weight. The thread alas is too short for the SME but I have extra length so no sweat. All good otherwise*****
Was this helpful to you? Yes / No
This review has not been appraised.
Much cheaper than an original replacement part and good quick service from Analogue selection. Recommended *****.
Home > Accessories > Turntable and Tonearm Essentials > Headshell Leads & Cartridge Fitting Essentials