Online orders are operating as normal. Read more here »
VTA Adjuster kit for Rega locknut fixing tonearms
Finally, a clever inexpensive, solution to a Perplexing problem! No more arm removals to insert washers for adjusting the VTA of you phono cartridge. Simply install the Isovert on your Rega RB250, RB300, RB600 or RB900 or any Rega derivative arms
NOTE: The Isovert requires a 1 1/8 diameter-mounting hole. This may require enlargement of the existing mounting hole
Installation of the Isovert raises the tonearm 1.75mm from the standard. This is slightly less than the thinnest shim (2mm) that Rega ManufacturesIf your arm is already at the right height or correct VTA before installing the Isovert ,and no Rega VTA shims are installed the arm will be too high with the Isovert even at the lowest setting unless you can lower the arm board. The Isovert should not be used.
**Kit comprises a VTA adjuster and hand adjustable bottom tone arm fastening speed nut**Fits Rega RB250 RB300 RB600 RB900 also Moth and other Rega derivative arms with single mount not 3 point mount.
VTA adjustment kit makes it easy to adjust the VTA. Take notice that the base height rises 1.75 mm. Before installing it, make sure to mark the central position carefully. For instance by drawing the outer Line of the arm on the plinth before removing it. With a file the hole needs to be enlarged, so you need some confidence. But it is doable and the end result is very nice.
Was this helpful to you? Yes / No
1 of 1 people found this review helpful.
IsoKinetik Cartridge stabiliser 3 gram£14.99
IsoKinetik Ceramic bearing upgrade for Rega Turntables£19.99
IsoKinetik IsoEnd Rega RB250 Upgrade End Stub£19.99
Home > Accessories > Turntable and Tonearm Essentials > VTA Adjusters and Spacers