Manufacturer
SME Series V Alignment Protractor
Zoom  Zoom

SME Series V Alignment Protractor

  (3 Reviews)
£12.64    
£10.53 Exc. VAT |  |

 

 

SME Series V Alignment Protractor. 

Please Note. The spindle hole in the protractor is oversize. The spindle bush adaptor supplied with the SME V Tonearms, must be used in order to centralise the spindle hole cut out.

 

 

 

 

 

Average Rating (3 Reviews):  
Write a Review and share your opinions!

Rating:  
Not very practical
12 April 2024  | 

The centre hole is too large and requires the spindle bush. Why?

Was this helpful to you?  Yes  /  No

This review has not been appraised.


Rating:  
SME SERIES V - 9 inch Alignment Protractor
06 October 2022  | 

I own a SME 20/2 turntable and would like to replace the old alignment protractor by a new one more platicized, solid, just like the anti skating adjustment tool. Looking at the picture, I thought it was the case but it’s not and I am a little disappointed.

Was this helpful to you?  Yes  /  No

This review has not been appraised.


Rating:  
Simple and effective alignment tool
02 August 2020  | 

This was very straightforward to use. Most of these tools require one to point a printed line at the tonearm pivot point which can be a bit arbitrary without additional tools. For this gauge you look down to be sure the tonearm is centered within the parallel lines and then drop the needle in the X and adjust as needed. Since the headshell for this tonearm is not slotted, the proper setup can be a bit more involved, so it's nice that the gauge is easy to use. Recommended if you have this SME 309 tonearm.

Was this helpful to you?  Yes  /  No

1 of 1 people found this review helpful.

01733 350 878
GBP EURO USD YEN   TOTAL: £0.00    View Basket 
Analogue Seduction