DNM Stereo Solid Core Precision 2 Speaker cable - New design
£19.20 per metre UN-TERMINATED
Precision 2 speaker cable is 19.5mm wide (0.8mm wider than the original Precision cable) with lower resistance due to thicker 0.82mm cores. Precision 2 Datasheet here.
This latest stereo solid core Precision 2 cable from DNM has a balance of parameters to enable it to work in a wide variety of hi-fi systems. This allows longer cable runs, less sensitive speakers and higher power amplifiers to be used.
The ribbon dimensions are set to reduce the capacitance and slightly increase the inductance, to ensure amplifier stability with longer runs of cable. The result is a stereo ribbon 19.5mm wide with the same facility for easy installation as the Precision cable but with a much higher performance in medium to low sensitivity speaker systems. DNM Stereo Solid Core cable is semi-transparent, fully colour coded and only 19.5mm wide x 2.2mm thick. The cable ribbon is designed to easily "unzip" to separate the dual speaker lines and the individual conductors to allow easy fitting of the speaker plugs.
The recommended way of using the new DNM Stereo Solid Core Speaker cable is as follows :- The cable directionality can be determined by noting that the print runs in the same direction as the signal. At the amplifier end separate the cable just enough to allow the plugs to be fitted and plugged into the amplifier. Then try to run the ribbon complete without separating it as far as possible towards the speakers to gain the full performance benefit of the fixed spacing of all the conductors. Run the cable along the planned path to the furthest speaker before cutting it to length. Then separate the cable ribbon into the two channels back to the point midway between the speakers to allow connection to the left and right speakers.
Before ordering DNM Stereo Solid Core cable please read these brief notes.
To single-wire a stereo speaker system, order only one length. For example for a 3.0m pair just order 3.0m To place the order, enter the length required (To the nearest metre) to reach the speaker furthest away from the amplifier. The speaker closer to the amplifier is connected by unzipping the cable just enough to separate the ribbon back to a point midway between the speakers. See the datalink sheet below
http://www.dnm.co.uk/datasheets/stereocable_install_and_drawing.pdf
To bi-wire a stereo speaker system. For example for a 3.0m pair just order 6.0m To place the order, enter the length required (To the nearest metre) to reach the speaker furthest away from the amplifier. The speaker closer to the amplifier is connected by unzipping the cable just enough to separate the ribbon back to a point midway between the speakers.. See the datalink sheet below
http://www.dnm.co.uk/datasheets/stereocable_install_and_drawing.pdf
