Shop by Price
Walker Audio Extreme Treatment E-SST Super Silver Treatment
Zoom  Zoom

Walker Audio Extreme Treatment E-SST Super Silver Treatment

The sonic improvements will just amaze you!

£140.82 Exc. VAT |  


Walker Audio Extreme Treatment E-SST Super Silver Treatment

Highly Recommended by Stan Ricker! 2004 & 2005 Positive Feedback Brutus Award Winner! Blue Moon Award & Stereo Times Publisher's Choice Award Winner! Hailed as the "Best Tweak Ever" by!

The ultra-pure silver flake is finer than standard SST and is further improved by slow, deep immersion cryogenic treatment.

Walker Audio Extreme SST (Super Silver Treatment) Contact Enhancer will dramatically improve the sound and/or video of any system. The highs will be more extended, cleaner, clearer and better focused. The mid-range will be more transparent with more articulation and detail, yet without harshness or glare. The bass will be stronger, tighter, and quicker. The soundstage will take on a more natural presence. With video systems, the sound improvement will be matched by the improvements to the video. Look for a cleaner, more three-dimensional picture.

Stan Ricker uses the Extreme SST in his mastering system! Stan is well known for his keen hearing and attention to details that some others do not understand. "The difference is in the details," says Stan. He has cut many highly regarded LPs for Mobile Fidelity Sound Lab, Crystal Clear, Telarc, Delos, Reference Recordings, Windham Hill, Stereophile, and roughly a dozen other labels, including recent work for Analogue Productions and AcousTech Mastering. He is currently the Owner/Engineer Of SRM.

CAUTION!!! Use at your own risk. Please read the instructions fully before proceeding. E-SST is highly conductive. If you bridge the gap between hot and ground with E-SST, you run the risk of damaging your system. Used as directed. E-SST can be removed by using a clean cotton swab or one of the unused applicators dipped in alcohol, fingernail polish remover, or contact cleaner.

Treating Interconnects:
Use one of the supplied applicators to apply a very small amount of E-SST to the male end of the interconnect. Spread it thinly on about ½ or ¾ of the length of the centre pin. Apply E-SST to the outside only of the female end in a thin even coat. Now, plug in your interconnect and listen. On XLR interconnects, apply to male pins only. DO NOT put the applicator into the RCA or you will short it out.

Treating Power Cords:
Apply a thin even coat of E-SST to the male ends only. Cover both sides of the pins about half the length of the pins. On the I.E.C. male end at the component, do the same. Use only a very small amount. Do not over apply.

Treating Speaker Cables:
Apply a thin even coat of E-SST to the contact area of the spades or bananas.

Treating Valves/ Tubes:
We experienced a big improvement when we applied E-SST to the pins of the tubes in our amplifiers. We suggest cleaning the pins with fine sandpaper in the direction on the pins. Clean with a contact cleaner, then apply a thin, even coat of E-SST to about 2/3 the length of the male pin.

Video/Other Uses:
E-SST works great on video connectors. Apply to the male pins and the outside of female connectors. SST also works on fuses and any contact device.

Be the first to Write a Review for this item!

Customers who bought this item also bought:

01733 350 878
GBP EURO USD YEN   TOTAL: £0.00    View Basket