THE Q UP Automatic Tonearm Lifter
Zoom  Zoom

THE Q UP Automatic Tonearm Lifter

  (1 Review)

Safely lifts your tonearm at the end of the record

£37.49 Exc. VAT |  



The Q UP Automatic Tonearm Lifter  

Please read the excellent review by clicking here.

The Q UP is a high precision device that safely lifts your tonearm at the end of the record. The Q UP can be installed in minutes, without tools, and is designed to fit on most manual turntables. Based upon a trigger and lift design, now reborn and modernised to work with either classic or contemporary turntable/tonearm combinations. The Q UP can be configured for a variety of tonearm heights, thicknesses and shapes. The Q UP only interacts with the tonearm at the end of the record and does NOT adversely effect the tonal quality of your system in any way. 

No need to worry about falling asleep with your record playing, or forgetting it is playing if you get distracted.

Includes 3 (three) stackable platforms that can further elevate The Q UP for turntables with thick platters. 

Full installation instructions can be found here: 


There are three simple issues that need to be met for The Q UP to be compatible. 

  • First: The tonearm must be a pivot type and NOT linear tracking
  • Second: You will need 14 mm of space between the tonearm and the platter. Slightly less if you are setting up the lifter without the base unit.
  • Third: The minimum height between the base where you will set up The Q UP and the bottom of the tonearm when playing a record is 36 mm if you are using a base unit OR 34 mm if your are setting it up without the base unit.

Printable compatibility templates and instructions can be found here:



The following list of turntables is a ROUGH GUIDE. The Q UP should fit at least one OR all of their models. If you are not sure then please refer to the template for verification.





 Linn Sondek






 Clear Audio 


 J.A. Michell 










 Music Hall 



Average Rating (1 Review):  
Write a Review and share your opinions!

optional upgrade
16 November 2020  | 

I am still setting this up on my manual turntable. Takes a while to get it right. There are a couple risers included so it should work on most T.T.

This is the second one of these I've used in my 50 years of spinning vinyl. Just remember to reset the trigger after every side played or you will get a nasty surprise 3/4 the way through the next side.

Was this helpful to you?  Yes  /  No

1 of 1 people found this review helpful.

Related Products
Little Fwend Tonearm Lifter
Moerch UP-4 Tonearm

Moerch UP-4 TonearmFrom:  £1,530.00

VPI Lifter/Cueing Device
01733 350 878
GBP EURO USD YEN   TOTAL: £0.00    View Basket 
Analogue Seduction