Manufacturer
Browse Shop
Analogue Studio Anti-Skating Bias Weight (With Thread)
Zoom  Zoom

Analogue Studio Anti-Skating Bias Weight (With Thread)

  (4 Reviews)
€10.49    
€8.74 Exc. VAT |  |

Analogue Studio Anti-Skating Bias Weight (With Thread)

This is a straight replacement if your anti skating weight is damaged or lost.

The Anti-Skate Weight is attached to a thin fishing wire that hoops onto the rear of some tonearms and hangs over the Anti-Skate Hoop. This allows for the perfect amount of counter-drag on the tonearm (all tonearms have a natural side-ways momentum), reducing the inclination to 'skip' or 'skate'. This weight is a perfect replacement for most tonearms which use this type of weight. Also handy as a spare.

Weight is 4grams, 8.8mm diameter, 80mm from bottom to thread loop.

*Please Note: This weight is supplied pre-attached to the fishing wire. 4.0g weight, including the nylon line

 

Average Rating (4 Reviews):  
Write a Review and share your opinions!

Rating:  
Exactly as the original
10 November 2021  | 

Great quality item

Was this helpful to you?  Yes  /  No

This review has not been appraised.


Rating:  
Anti-Skating Weight
11 November 2020  | 

Good quality.

Was this helpful to you?  Yes  /  No

This review has not been appraised.


Rating:  
Black bias 4 grams (+) as described
15 March 2020  | 

For my last slowly in process SME 'Improved' in heavy effective mass conversion I needed such a heavier bias weight. The thread alas is too short for the SME but I have extra length so no sweat. All good otherwise*****

Was this helpful to you?  Yes  /  No

This review has not been appraised.


Rating:  
ANALOGUE STUDIO ANTI-SKATING BIAS WEIGHT (WITH THREAD)
23 July 2018  | 

Much cheaper than an original replacement part and good quick service from Analogue selection. Recommended *****.

Was this helpful to you?  Yes  /  No

This review has not been appraised.

01733 350 878
GBP EURO USD YEN   TOTAL: €0.00    View Basket