Manufacturer
Graham Slee Solo Ultra Linear Diamond Edition Headphone Amplifier

Graham Slee Solo Ultra Linear Diamond Edition Headphone Amplifier

  (1 Review)
£670.00    
£558.33 Exc. VAT |  |

 

 

Graham Slee Solo Ultra Linear Diamond Edition Headphone Amplifier (Includes PSU1 Power Supply)

The new Solo Ultra-Linear Diamond Edition hi-fi headphone amplifier gives you the sound you always wanted from a headphone amp! A headphone amplifier truly capable of making good headphones deliver a lifelike, dynamic and breathtaking performance with a real out of head three-dimensional stereo sound stage.

The Ultra-Linear voltage amplifier stage gives you the smoothness and warmth of a tube amp, yet with all the precision, fine detail, and punchy sound of the solid state amp it is. Plus, it won't wear out like tubes.

Make the Solo Ultra-Linear Diamond Edition your reference!

 

 

Features

Ultra-low noise:the Solo Ultra-Linear Diamond Edition is now also ultra-low noise as well as being ultra-linear.

Higher output current: its output stage has been beefed-up to take control of the most difficult headphones with ease.

No dangerous DC on the headphone output prevents headphone damage: it only takes a small amount of DC offset to heat up the windings of headphone transducers. That heat softens the adhesive which keeps the "voice-coils" in place, and eventually your headphones don't perform all that well. All our headphone amplifiers block DC offset from reaching your headphones.

Tape monitoring: the Solo Ultra-Linear Diamond Edition headphone amplifier has two inputs and a non-shorting mute. Its input switching can be used in tape monitoring as shown here.

(An extra pair of interconnects are required as well as two phono tee-adapters inserted where indicated by the asterisks shown in the diagram)

When connected as per this suggestion, the input selector on the Solo front panel mimics a tape monitor switch. In position 1, the same source as selected on the amplifier is fed to the Solo; in position 2, the output from the tape recorder (or other recording device) is fed to the Solo.

Headphone sensitivity volume control: unlike conventional volume controls, this one is designed to be used over its full rotation to compensate for a wide range of headphone impedances and sensitivities. This avoids the use of gain switches which would otherwise result in differing performance characteristics depending on the gain setting.

 

 

 

Specification

Headphone impedance range: 8 to 2,000 Ohms / 16 to 600 Ohms preferred

Power output: (rms, both channels fully driven at 1% THD)
32 Ohms: 140mW/channel; 600 Ohms: 30mW/channel

Input sensitivity (for specified power output into 32 Ohms): 511mV rms

Input impedance: 37k Ohms at max volume; 50k Ohms at min volume

Distortion: (THD plus noise at 9 o'clock volume control setting (qtr power))
10Hz-20kHz: better than 0.04%; 10Hz-1kHz: better than 0.02%

Frequency response (±0,-3dB) 10Hz - 35kHz

Output noise: (22Hz-22kHz, quasi-peak/un-weighted) -95dB

Channel balance: better than 1dB

Crosstalk: Left to Right -56dB; Input to Input -68dB

Input selector centre-off position: non-shorting; -38dB at max volume with 2V rms input (ref: 1kHz and 10kHz)

Output Stage: Bipolar class AB

Supply voltage: 24V DC unipolar

Size: (approx.) W: 107 x H: 50 x D: 185 (mm) inc. controls

 

 

 

Average Rating (1 Review):  
Write a Review and share your opinions!

Rating:  
Excellent headphone amplifier
24 June 2020  | 

I have a Luxman 590 AX MK II which does have a very good headphone output, this Graham Slee really is a step up in sound quality.

It has such a silent background, music is warm but with incredible detail.

Once you start listening you are so drawn in you can listen for hour’s.
Excellent!

Was this helpful to you?  Yes  /  No

13 of 13 people found this review helpful.

01733 350 878
GBP EURO USD YEN   TOTAL: £0.00    View Basket 
Analogue Seduction