Shop by Price
Ringmat Isolation Spike Stopper Domes
Zoom  Zoom

Ringmat Isolation Spike Stopper Domes

£41.25 Exc. VAT |  


Ringmat Spike Stopper Isolation Domes

  • Protect your floor and enhance the sound at the same time.
  • Use Ringmat Spike Stoppers under loudspeakers, systems tables and any other spiked supports under hi-fi and audio-visual equipment.

Ringmat Spike Stoppers can be used on their own and in terms of sound quality will outperform other spike protection support products. There will a massive improvement in performance if used on wooden and other smooth, flat floors in conjunction with a Statfoot. Nevertheless, for best results, Spike Stoppers should be used on top of Ringmat Feet.

Each Spike Stopper is made of compressed cork. Spike Stoppers are designed to be used on a level surface with the flat base resting upon the surface below (or on top of Ringmat Feet). This allows for the spike in the loudspeaker, systems table or other spiked support to be placed in the spike hole on top of the Spike Stopper.

Spike Stoppers are designed to grip the sides of the spikes rather than have the weight bearing applied through the point of the spike. If the spikes are not wide enough to be gripped firmly at the sides in the Spike Stopper holes, wider/fatter versions of the spikes must be used.

Each set of Ringmat Spike Stoppers contains one denser, blue speckled Dome, where the cork has a synthetic rubber binder. As a general rule, place the denser Spike Stopper underneath the spike bearing the least weight above. For example, if most of the weight carried by the support is at the rear, place the denser Spike Stopper underneath the front right hand spike. If most of the weight is at the front, place it underneath one of the rear spikes. With supports carrying a turntable, place it under the front left hand spike instead of under the front right hand spike. The other Spike Stoppers can then be placed in the remaining required positions.

When three spikes are in use, again place the denser Spike Stopper underneath the spike bearing the least weight. Some experimentation may be worthwhile. Ideally, the least weight should be on the side where two spikes are positioned but unfortunately the loudspeaker or systems support manufacturers will have already positioned the spikes, and are inclined to place two spikes under the heaviest side rather than under the lightest side.

Spike Stoppers enable loudspeakers and equipment to provide a sound quality that is superior to using traditional spikes alone, especially when used in conjunction with Statfeet.


Spike Stopper








upto 69Kg

in sets




upto 29Kg

in sets




Be the first to Write a Review for this item!

Customers who bought this item also bought:

01733 350 878
GBP EURO USD YEN   TOTAL: £0.00    View Basket